四虎一国产精品一区二区影院I午夜精I最好看的中文字幕I欧美黑人欧美精品刺激I69福利社区I9i精品福利一区二区三区I亚洲va国产va天堂va久久Ijiizzyou欧美2I第四色在线视频I综合视频一区二区I欧美日韩综合精品I欧美少妇xxxI91调教打屁股xxxx网站I国产在线视频网I亚洲精品视频大全I日本激情视频I天堂a在线观看I成人欧美一区二区三区黑人冫I性欧美xxx内谢I成人免费毛片视频I好了av在线第四站综合网站I国产精品视频免费播放I久久成人国产精品入口I在线观看免费vaI调教女m荡骚贱淫故事

DONDE SEAL

CHINA

Professional Of Mechanical Packing & Industrial Gasket

6.Torque bolts in a minimum of four stages as listed in Steps 7, 8, 9, and 10 below.

7.   7.Torque the bolts up to a maximum of thirty percent of the final torque value required following the sequence recommended. (See charts for bolting sequence.) Number bolts so that torquing requirements can be followed. With any gasket material, it is extremely important to follow a proper bolting sequence. If this sequence is not followed, the flanges can be cocked. Then, regardless of the amount of subsequent torquing, they cannot be brought back parallel. This problem, of course, is maximized on metallic gaskets more so than on nonmetallic.

8.   8.Repeat step 7, increasing the torque to approximately 60 percent of the final torque required.

9.   9.Repeat step 8, increasing the torque to the final torque value.

1   10.On high-pressure, high-temperature applications, it is suggested that the flanges be retightened to the required stress after 24 hours at operating pressures and temperatures to compensate for any relaxation or creep that may have occurred. >>The End

[1]

[2]

BACK

Total 2 Page 2/2