四虎一国产精品一区二区影院I午夜精I最好看的中文字幕I欧美黑人欧美精品刺激I69福利社区I9i精品福利一区二区三区I亚洲va国产va天堂va久久Ijiizzyou欧美2I第四色在线视频I综合视频一区二区I欧美日韩综合精品I欧美少妇xxxI91调教打屁股xxxx网站I国产在线视频网I亚洲精品视频大全I日本激情视频I天堂a在线观看I成人欧美一区二区三区黑人冫I性欧美xxx内谢I成人免费毛片视频I好了av在线第四站综合网站I国产精品视频免费播放I久久成人国产精品入口I在线观看免费vaI调教女m荡骚贱淫故事

Insert the gasket carefully between the flanges.

The gasket has to be centralized in the flange.

Ensure that the gasket is installed in a dry state.

It is important that the gasket is not pinched or otherwise damaged when bringing the flanges together.

Lubrication of bolts                                   

Apply lubricant to the bolt and the nut threads as well as to the face of the nut to reduce friction  when tightening

Pay attention that the lubricant does not contaminate the gasket or the flange surfaces.

The recommended  service temperature of the lubricant has to be within the process service temperature limits.

Bolt tightening 

Make at least 4 stages to the required torque as follows:

finger tighten bolts

use 30% of the required torque

use 60% of the required torque use the full torque

Close the torquing  with one final pass in a clockwise sequence.

Retightening

If retightening is considered necesary, this should only be done at ambient temperatures before or during the first start-up.

Never retighten compressed fibre gaskets at higher operating tempera- tures and longer operating times.

Re-use of gaskets

For safety reasons never re-use a gasket.

The cost of a gasket is minimal compared with the costs which will come into being of a down time of the plant.

>>The End